Jerry Treiman reported in a message board thread about a U.S. The overall quality of watches produced by Standard was well below the high grade watches that Keystone-Howard offered and the New York Standard plant may not have had the necessary capability of such fine work.īack in 1901, the Philadelphia Watch Case Co. ![]() The reason for the quotation marks is that the term "finish" in the watch industry usually refers to the process of turning a set of raw movement parts into a smoothly functioning movement, as well as adding whatever decorating and polishing that was to be done. However, it may be that the "finishing" may have simply meant mounting a dial and placing the movement in a case. It has been said that Keystone "finished" these watches at the New York Standard Watch Co., a firm, based in New Jersey, already owned by Keystone. Howard name by the American Waltham Watch Co., which Keystone-Howard then marketed (see these 19-Apr-09 and 10-May-09 posts on the subject by Jerry Treiman). At first, the firm had watches built under the E. ![]() Howard & Co.) sometime around 1903, reportedly to provide a market for their better grades of cases. purchased the rights to use the Howard name on watches (Note: from E. ![]() The following information is mostly based upon “The Howard Ten Size Watch,” Arthur N.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |